make me a checklist on how to do an oil change

Gather necessary tools and materials: oil, oil filter, wrench, oil pan, funnel, gloves, rags, jack, jack stands, and safety goggles.

Ensure the car is parked on a flat surface and the engine is cool.

Put on safety goggles and gloves.

Position the jack under the car's frame and lift the vehicle.

Secure the car using jack stands.

Locate the oil drain plug under the engine.

Place the oil pan beneath the drain plug.

Unscrew the drain plug using a wrench.

Allow the old oil to fully drain into the pan.

Replace the drain plug and tighten it securely.

Locate the oil filter, typically near the drain plug.

Position the oil pan beneath the oil filter.

Unscrew the oil filter using an oil filter wrench.

Allow any remaining oil to drain into the pan.

Apply a small amount of new oil to the rubber gasket of the new oil filter.

Screw the new oil filter onto the engine by hand until snug, then tighten it an additional 3/4 to 1 turn using the oil filter wrench.

Locate the oil filler cap on top of the engine.

Remove the cap and set it aside.

Insert a funnel into the oil filler hole.

Pour the appropriate amount and type of new oil into the funnel.

Wait for a few minutes to allow the oil to settle.

Check the oil level using the dipstick, and add more oil if necessary.

Replace the oil filler cap securely.

Start the car and let it run for a few minutes to circulate the new oil.

Turn off the engine and wait for a minute to allow the oil to settle.

Check the oil level once again and ensure it is within the recommended range.

Inspect for any oil leaks around the drain plug and oil filter.

Lower the car using the jack and remove the jack stands.

Clean up any spilled oil and properly dispose of the old oil.

Record the date and mileage of the oil change for future reference.

Note: This checklist serves as a general guideline. Always refer to your vehicle's owner's manual for specific instructions and recommended oil type.