LAUNDRY MAINTANCES CHECKLIST
Washing Machine
- Inspect the area around the washing machine for any water drips or puddles
- Check the hoses and connections for any visible signs of leakage
- Remove the detergent dispenser drawer
- Soak it in warm soapy water
- Scrub with a brush to remove any residue
- Rinse thoroughly before placing it back
- Pour 2 cups of white vinegar into the detergent dispenser
- Run the washing machine on the hottest setting
- Allow the cycle to complete to help remove any buildup and odors
- Check the hoses for any cracks, bulges, or signs of wear
- Tighten any loose connections
- Inspect the drum for any dark spots or musty odor
- Wipe down the drum with a solution of water and bleach to remove any mold or mildew
- Wipe down the rubber door seal with a damp cloth
- Remove and clean the filter according to the manufacturer's instructions
- Run a wash cycle and check if water is entering the machine properly
- Ensure there are no leaks around the inlet valves
- Visually inspect the belts and pulleys for any fraying or damage
- Replace any worn out belts or pulleys to prevent further issues
- Remove the front panel of the washing machine
- Inspect the drain pump for any obstructions or debris
- Clear out any clogs to ensure proper drainage
Dryer
- Locate the lint trap usually inside the door or at the top of the dryer
- Remove any lint by hand or with a brush
- Replace the lint trap back in its place
- Disconnect the dryer from the power source
- Remove the vent hose from the dryer
- Check for any lint or debris blocking the vent
- Clear any blockages and reattach the vent hose
- Run the dryer on a cycle and listen for any unusual sounds
- Stop the dryer if you hear anything unusual
- Investigate the source of the noise and address accordingly
- Turn on the dryer and select a high heat setting
- Feel for heat coming from the dryer
- If there is no heat, the heating element may need to be replaced
- Use a damp cloth or dryer sheet to wipe down the inside of the drum
- Remove any stains or residue
- Ensure the drum is dry before using the dryer
- Inspect the rubber seal around the dryer door for any tears or gaps
- Replace the seal if it is damaged to prevent leaks and improve efficiency
- Turn off the dryer and unplug it from the power source
- Open the dryer cabinet and inspect the belt for cracks or fraying
- Replace the belt if it shows signs of wear to prevent damage
- Use a level tool to check if the dryer is sitting evenly on the floor
- Adjust the dryer's feet or placement if needed to ensure it is level
- An unlevel dryer can cause noise and vibration during operation
- Run the dryer on different settings such as high heat, low heat, timed dry, etc.
- Ensure all settings are functioning properly
- Address any issues with settings or functions as needed
Use in Manifestly