checklist for checking electrical points chasing marked at site
1. Pre-Inspection Preparation
2. Site Assessment
3. Verification of Marked Points
4. Chasing Inspection
- Use a measuring tape to verify depth and width.
- Ensure measurements match project specifications.
- Inspect each point individually for consistency.
- Document any discrepancies for reporting.
- Review project specifications prior to inspection.
- Check alignment with approved drawings.
- Ensure proper tools and techniques were used.
- Assess overall quality of the chasing work.
- Inspect adjacent walls and surfaces for cracks.
- Look for signs of structural integrity compromise.
- Document any observed damages with photos.
- Report damages to the project manager immediately.
5. Quality Control
- Use a level to check horizontal alignment.
- Confirm vertical alignment with a plumb line.
- Measure distances from walls to conduits and boxes.
- Adjust placements as needed for compliance.
- Review project specifications and standards.
- Inspect labels and certifications on materials.
- Check for compatibility with project requirements.
- Document any discrepancies for reporting.
- Conduct a visual inspection of the chased areas.
- Remove any loose debris or obstructions.
- Ensure clear access for installation and inspection.
- Report any issues that may affect installation.
Use in Manifestly