Quality inspection report of GRP enclosure
1. Pre-Inspection Preparation
2. Visual Inspection
- Inspect for scratches, dents, or imperfections.
- Ensure no warping or deformation is present.
- Check for color consistency across the surface.
- Run fingers over the surface to feel for roughness.
- Look for any uneven texture or bubbling.
- Ensure the finish is appropriate for the intended environment.
- Examine joints and edges for separation.
- Check for hairline fractures or large cracks.
- Identify any unusual color variations or blotches.
- Ensure labels are clear and legible.
- Check for compliance with industry standards.
- Confirm the labels are securely affixed and undamaged.
- Check for surface defects like cracks, blisters, or delaminations.
- Inspect edges and corners for sharpness and proper finishes.
- Verify that all mounting points are intact and undamaged.
- Look for color consistency across the entire enclosure.
- Ensure there are no signs of excess resin or rough patches.
- Examine seals and gaskets for wear or improper installation.
- Check for proper labeling and identification on all surfaces.
- Look for dirt, dust, or chemical residues.
- Use a soft cloth to wipe the surface.
- Check for signs of mold or biological growth.
- Open and close all access points smoothly.
- Ensure hinges are functioning without obstruction.
- Look for gaps between doors and frame.
- Inspect seals for cracks or brittleness.
- Check for proper seating and alignment.
- Ensure no gaps are present that could allow ingress.
- Inspect for uniformity in joint appearance.
- Check for signs of separation or weakness.
- Ensure joints are properly bonded and sealed.
- Inspect for water stains or corrosion.
- Check interior surfaces for moisture.
- Ensure drainage is functioning properly.
- Check for missing screws, bolts, or nuts.
- Inspect for rust, corrosion, or damage.
- Ensure all fasteners are tightened to specifications.
- Look for fading or chalking on surfaces.
- Inspect for brittleness or cracking due to UV exposure.
- Assess the need for protective coatings.
- Test each access point for ease of use.
- Remove any debris blocking the access.
- Ensure locking mechanisms work smoothly.
- Check that openings are unobstructed.
- Ensure adequate airflow is provided.
- Inspect for any signs of blockage or damage.
- Check for tightness and security of brackets.
- Inspect for rust or structural damage.
- Ensure brackets are aligned and properly positioned.
Use in Manifestly